The CL for myopia control was the MiSight® (Cooper Vision, Fairport, NY, US) and it had a nominal power of −3.0 D. The MiSight® is not only focused on myopia control as they also provide vision correction for the underlying ametropia. According to the manufacturers information, this lens present two zones devoted to far vision and two treatment zones (addition zones).

In order to show the differences with a multifocal design, a similar design was chosen for this work. This lens was the Acuvue® Oasys® for Presbyopia (Vistakon, Inc., Jacksonville, FL, USA) because it also has a multizone design with five alternating distance and addition zones. This lens is available in a variety of addition powers. It is expected that the higher addition power would create the higher optical power variations. Then, in order to show the minimum potential differences between both designs, the lens analysed in this work had “High” addition and it also had a nominal power of −3.0 D.

The instrument used to generate the power profile of the lenses was the Visionix VC 2001 CL power analyser (Visionix Ltd, Jerusalem, Israel).4 The measurements were taken from the centre of the lens to a radial distance of 3.0mm of aperture (total diameter of 6.0mm). The Visionix VC 2001 CL uses the Hartmann–Shack principle for calculating the power profiles and it is considered an acceptable method for this purpose. However, it should be mentioned that other instruments, for example, those based on the Phase-Shifting Schlieren’ technique have shown higher resolution. This should be taken into account at the moment of addressing small amounts of diopters (D) in this work.

For this study, the ISO18369-3 recommendations were followed and Before each analysis, lenses were soaked in a saline solution at room temperature during one day. The lenses were inserted in the wet cell of the instrument. Three lenses of each model were measured and three measurements of each lens were made.

The power profiles of the lenses for 6.0mm of aperture are showed in Fig. 1 (myopia control) and 2 (bifocal). The horizontal bands in both figures indicate 1.0 D steps. These figures show how the myopia control CL presents a total of three concentric refractive annuli while the bifocal presents five.

Figure 1.

Power profile of the soft contact lens designed for myopia control: MiSight.

(0.1MB).

The positive refractive annuli of these lenses are responsible for the creation of the myopic defocus. Observing the Fig. 1, it is possible to see that the myopia control CL presents a 2.0mm central ring devoted to far vision. Beyond 2.0mm of diameter, there is only one complete positive annular ring at around 4.0mm and other negative ring at around 5.0mm. The fact of presenting only one positive ring suggests that for pupils under 4.0mm, the amount of peripheral relative myopic defocus could be compromised. This should be taken into consideration because it has been reported that large pupil diameters facilitate the effect of slowing axial growth in myopia due to the enhancement of the myopic shift in the peripheral retina.5 It should be mentioned that the exposure of the ring will be positive in terms of myopic blur effect but will create a ghost retinal image. As the manufacturer suggests, this lens present other positive ring for apertures over 6.0mm. It should be considered due to other positive ring may increase the ghost retinal image but it would also help in the creation of the myopic blur effect.

Conversely, the bifocal CL presents five narrower rings. The central one devoted to far vision is positioned within 1.0mm from the centre. It means that even for smaller pupils some ring will be completely exposed and some myopic blur and positive addition should be created on the retina. This is interesting for creating myopic defocus, however, more refractive annular rings may induce more visual disturbances by the increase in the scattering into the eye.6

Despite their differences, both lenses should provide constant myopic defocus blur effect for children at both distance and near, since children do not use the near portion of the lens for near tasks, as presbyopic adults do. It is because the annular rings devoted to near vision do not provide near acuity as good as can be obtained through accommodation by young subjects.2

Even if a proper demonstration should be addressed in future studies, the higher changes in the power at the edge of these lenses may imply a higher peripheral relative myopic defocus. In relation to this and considering similar accommodative responses, these changes are showed to be higher for the myopia control CL: around 3.0 D for the inner and 4.5 D for the outer zone (Fig. 1) versus 1.5 D at the inner and 3.0 D at the intermediate and the outer zones of the bifocal (Fig. 2).

Figure 2.

Power profile of the simultaneous vision multifocal soft contact lens: Acuvue Oasys for Presbyopia.

(0.11MB).

Both figures show that the centre of the lenses (devoted to far distance) does not reach the nominal distance power of the lens (−3.0 D), being slightly more positive. A higher nominal power of the lenses implies a higher addition, however, this may impact on distance vision. Therefore, this positive over-correction (around 0.5 D) should be taken into consideration by clinicians at the moment of prescribing the nominal power of these lenses.

Finally, it should be mentioned that a decentration of these annular designs could alter their optical performance.7 Hence, after the current analysis it is clear that the studies that will analyse the effectiveness of these lenses on myopia progression should properly control two parameters: the pupil dynamic of the patients and the centration of the lenses.

In summary, the myopia control CL seems to show some optical improvements for the use of these lenses in children. Nevertheless, future studies should analyse if these optical features are enough in terms of effective myopia control of the patients and the visual effects that this design could cause.

The author has no proprietary interest in any of the materials mentioned in this article.